2:12 Does the conjugate symmetry property of the Fourier series coefficients only hold for purely... Roel Van de Paar
4:39 Electronics: How much energy is required to create a sound with constant frequency and amplitude? Roel Van de Paar
2:57 Electronics: Help for VR sensor signal conditioning (variable reluctance signal conditioning) Roel Van de Paar
2:14 Electronics: Is it reasonable for a potentiometer to have a minimum of 1.3 s (3 Solutions!!) Roel Van de Paar
1:44 Electronics: How to reset all flags in 8085 without an arithmetic or logic operation? Roel Van de Paar
2:29 Electronics: Simple & basic approach to Indoor positioning.Is it possible? (2 Solutions!!) Roel Van de Paar
1:57 Electronics: Can I convert my 3.7 volt lithium ion batteries into a usb charging power bank? Roel Van de Paar
3:23 Electronics: Why does my DIY Barebones Arduino Due with SAM3x8E overheat on RESET press? Roel Van de Paar
2:08 What is the difference between the I2C interface and the "Grove" system? (2 Solutions!!) Roel Van de Paar
2:48 Electronics: Which circuit is better for low-noise, high-precision light sensing? (2 Solutions!!) Roel Van de Paar
3:07 Why is the capacitor considered lossless, even if it can store/give out energy? (6 Solutions!!) Roel Van de Paar
3:34 Electronics: Voltage drops when a signal is fed into op-amp comparator (2 Solutions!!) Roel Van de Paar
2:26 Electronics: Differential voltage measurement on shunt resistor (2 Solutions!!) Roel Van de Paar
4:19 Electronics: Why the diode has higher impact on dc characteristics than ac? (3 Solutions!!) Roel Van de Paar
2:25 Why are pull-up resistors required to be connected to the 2 lines of I2C? (3 Solutions!!) Roel Van de Paar
2:36 Electronics: What is the difference between neutral and ground? (2 Solutions!!) Roel Van de Paar
2:08 Is there an equivalent to Xilinx's ICON, VIO, ILA IP-Cores in Altera's SignalTap? Roel Van de Paar
3:24 Is it safe to "top up" bootstrap capacitors using a charge pump? (2 Solutions!!) Roel Van de Paar
2:29 Electronics: modbus_read_registers - ERROR connection timed out (2 Solutions!!) Roel Van de Paar
2:20 Combining resistors connected solely at one node, and also a question about parallel/series Roel Van de Paar
2:09 Why is the voltage drop across this 1 ohm resistor being neglected in this practice problem?... Roel Van de Paar
3:05 Electronics: Phase difference between voltage source's voltage and current (2 Solutions!!) Roel Van de Paar
2:04 Electronics: How come Misra C checker is such a prestigious tool? (2 Solutions!!) Roel Van de Paar
3:02 Electronics: Can I create a multiplexed array of IR photodiodes? (2 Solutions!!) Roel Van de Paar
3:38 Electronics: How to control a flag in two different procedural blocks in verilog? (3 Solutions!!) Roel Van de Paar
