3:06 verilog - altera fpga "error pin x has multiple drivers due to the non-tri-state driver" Roel Van de Paar
2:45 Electronics: How to convert sine wave from an oscillator to TTL signal for microcontroller? Roel Van de Paar
2:29 Why does this RL circuit gives out wrong results when a square wave generator is applied across it? Roel Van de Paar
4:11 Electronics: Understanding common terminal in common collector/emitter amplifier (3 Solutions!!) Roel Van de Paar
1:34 Electronics: Where can I found STM32L4 DSP and standard peripherals library? (2 Solutions!!) Roel Van de Paar
2:20 Electronics: Multiple analog inputs on A0 pin (ESP nodemcu) with PCF8574 (2 Solutions!!) Roel Van de Paar
2:52 Electronics: How to connect two circuits into on light bulb with a switch in each? (2 Solutions!!) Roel Van de Paar
2:01 Electronics: Why are fast blow fuses more tolerant to small over currents than slow blow fuses? Roel Van de Paar
2:37 Is connecting a 12V circuit to +12V and GND the same as connecting it to GND and -12V? Roel Van de Paar
2:38 Electronics: Do buck converters/voltage regulators change max amperage? (2 Solutions!!) Roel Van de Paar
3:58 Electronics: Opamp input voltage divider creates wrong voltage - what could be the cause? Roel Van de Paar
4:25 Electronics: RS485 termination: AC + failsafe + parallel + bidirectional (3 Solutions!!) Roel Van de Paar
2:10 Electronics: Length of Transmission Line & Characteristic Impedance (2 Solutions!!) Roel Van de Paar
2:18 Electronics: Is a valid USB VID/PID necessary for strictly embedded use of the Bus? (3 Solutions!!) Roel Van de Paar
3:02 Electronics: How long will an 6000 mAh battery pack power a 12v 60W amp for? (2 Solutions!!) Roel Van de Paar
2:35 Will this 18650 tp4056 parallel circuit work for charging and simultaneous power supply Roel Van de Paar
2:55 Electronics: How low an insulation resistance is too low for a residential electrical system? Roel Van de Paar
3:28 Electronics: SMD LED for microprocessor output without resistor (4 Solutions!!) Roel Van de Paar
3:03 What is the difference between half wave voltage doubler and full wave voltage doubler? Roel Van de Paar
2:35 Electronics: Why is the current control knob in DC voltage source kept at maximum initially? Roel Van de Paar
1:45 Why is Inrush current important to me when buying a power supply? (2 Solutions!!) Roel Van de Paar
3:23 Electronics: MPU6050 accel/gyro noise that behaves strangely - what might be doing this? Roel Van de Paar
3:18 STM32F0 (master) writing multiple bytes by I2C to MCP4728 (slave) using StdPeriphLibrary Roel Van de Paar
1:37 Electronics: Why does an increase in current increase the conductor temperature? Roel Van de Paar
2:33 Electronics: VHDL: Are if-else and case statements supposed to synthesize the same hardware? Roel Van de Paar
4:40 Is it good practice to always assign initial value and reset signals in digital design? Roel Van de Paar
2:08 Electronics: Comparing rated, stall, and inrush current in DC motor (2 Solutions!!) Roel Van de Paar
3:49 Electronics: Why don't most lab power supply units display the maximum current? (4 Solutions!!) Roel Van de Paar
4:07 Electronics: Why is a GROUND electrode needed with a referential amplifier? (4 Solutions!!) Roel Van de Paar
4:03 Electronics: What is the underlying mechanism behind Wi-Fi getting slower with greater distance? Roel Van de Paar
2:49 Electronics: Prevent corrosion of circuit board fallen in water (4 Solutions!!) Roel Van de Paar
4:06 Electronics: How to drive four nixie tubes with arduino?(in-14/clock)? (2 Solutions!!) Roel Van de Paar
3:11 Electronics: Wire gauge for low voltage, high current DC application (3 Solutions!!) Roel Van de Paar
3:27 Electronics: Connection Problem of Night vision IR led for RasPi Camera (4 Solutions!!) Roel Van de Paar
3:02 Where to add gain and volume controls to LM386 guitar amp circuit? (3 Solutions!!) Roel Van de Paar
