2:29 Electronics: Is There An Automatic Precision Screwdriver For Small Works? (2 Solutions!!) Roel Van de Paar
1:51 How are processes evaluated in VHDL if a signal appears/does not appear in a sensitivity list... Roel Van de Paar
1:50 Can I just T into a CAN bus network if I just want to observe the data? (2 Solutions!!) Roel Van de Paar
2:58 Electronics: High side mosfet 12V switch from isolated 3V3 GPIO always ON (2 Solutions!!) Roel Van de Paar
2:00 Using ATX PSU as stand-alone power supply: PSU doesn't stay on longer than ~1 second Roel Van de Paar
2:50 Electronics: Using boost converter and battery to power Peltier device (2 Solutions!!) Roel Van de Paar
1:22 Electronics: Is it possible to connect ac power source to battery in parallel connection s Roel Van de Paar
3:35 Electronics: Problems with Wien Bridge oscillator circuit simulation in Mutisim (2 Solutions!!) Roel Van de Paar
2:48 What kind of voltage controlled oscillators are convenient to obtain very low frequencies? Roel Van de Paar
1:24 Synthesisablity of using the index of an outer loop as variable limit for a nested inner loop? Roel Van de Paar
1:56 Can I safely place a 60w between a 50w LED and a large heat sink that can dissipate 100 watts? Roel Van de Paar
2:44 If I put an L298N between a 12V source and a 100W DC fan, what will happen? (2 Solutions!!) Roel Van de Paar
1:46 Electronics: Analog inputs with Intel Edison mini breakout board? (2 Solutions!!) Roel Van de Paar
2:26 Electronics: Name that thing... Circular 4-pin female connector (3 Solutions!!) Roel Van de Paar
2:31 Electronics: Is there a way to step up voltage without consuming power when there's no load? Roel Van de Paar
3:22 Electronics: How to simulate a 2 MHz crystal oscillator using LTSpice? (3 Solutions!!) Roel Van de Paar
1:32 What USB-2 cabling hardware do I need to connect two Windows 10 computers together? Roel Van de Paar
3:12 Why does one LED slightly influence the other parallel LED although controled by differenct... Roel Van de Paar
3:53 Creating a circuit with 3 lights and 4 switches (1 master switch) (4 Solutions!!) Roel Van de Paar
2:30 Why is my circuit's current far lower than expected with 2.6v / 220Ohm / and LED? (3 Solutions!!) Roel Van de Paar
1:35 Electronics: How to partition a combinational circuit into parts with equal delay? Roel Van de Paar
3:19 Electronics: Simulation is the same as my thinking,but different from the pape r(charging loop) Roel Van de Paar
3:24 Why is there a sudden change in current between $t=0^{-}$ and $t=0^{+}$ when an active inductor... Roel Van de Paar
3:13 Does frequency multiplier work with signal that contain multiple frequency components? Roel Van de Paar
2:05 Electronics: ACM2012-900-2P filter can be used on USB 3.0 lines of a Type-C connector? Roel Van de Paar
3:56 AVR interrupt service routine not executing as fast as expected (instruction overhead?) Roel Van de Paar
1:44 Segger J-Link GDB-Server / STM32100B-EVAL / Debugging hangs at first instruction Roel Van de Paar
1:44 Electronics: How do I take input from the joystick on the AVR butterfly development board? Roel Van de Paar
3:06 Electronics: Does an inexpensive screw terminal "expansion strip" exist? (3 Solutions!!) Roel Van de Paar
3:28 Electronics: Can the resistance between two points in air be calculated? How? (4 Solutions!!) Roel Van de Paar
2:25 Keil : LPC1768 UART : Error: L6200E: Symbol a multiply defined (by main.o and uart.o) Roel Van de Paar
2:05 Electronics: Error in simulating bdf with Waveform.vwf.vht, but bdf compiles successfully Roel Van de Paar
