3:45 Experiment with pull up/down resistors gives unexpected results (3 Solutions!!) Roel Van de Paar
3:27 Electronics: How to identify areas of a FPGA design that use the most resources and area? Roel Van de Paar
2:58 How to limit maximum voltage when it's 0.1V too high and the device controller complains? Roel Van de Paar
2:15 Electronics: Safety precautions when developing and testing mains voltage devices Roel Van de Paar
2:47 Electronics: identifying overshoots in given state space system with step inputs (3 Solutions!!) Roel Van de Paar
3:40 Electronics: Help understanding combined High/Low Pass filter circuit (2 Solutions!!) Roel Van de Paar
2:49 Electronics: How much amperage can pass through a current limiter? (3 Solutions!!) Roel Van de Paar
2:45 Electronics: How can I remove this (With picture...wire clip?)? (2 Solutions!!) Roel Van de Paar
1:19 Electronics: LTSPICE: How to display traces automatically when press Run Button? Roel Van de Paar
3:45 Electric motor setup to turn shaft at constant speed under variable load (4 Solutions!!) Roel Van de Paar
2:17 Electronics: Do all microcontrollers from one family have the same processor core? (3 Solutions!!) Roel Van de Paar
2:59 Electronics: Magnetic power connectors (ie. "dots") for slim power supply connection Roel Van de Paar
1:52 Electronics: DC motors run slow and weak. Can the culprit be the motor controller? Roel Van de Paar
3:09 Electronics: A short produced from an isolated power supply would like to travel to ground? Roel Van de Paar
1:38 Electronics: How can I switch multiple lines using a single switch? (2 Solutions!!) Roel Van de Paar
4:29 Electronics: How to find the cutoff frequency of an underdamped second order lowpass filter? Roel Van de Paar
7:00 Electronics: Why are electrically insulating heatsinks so rare? Is it just cost? (8 Solutions!!) Roel Van de Paar
2:10 Electronics: Does whole house surge protection device (SPD) protect from Ground (PE) surges? Roel Van de Paar
1:50 Electronics: What is the difference between a PUT and a normal transistor? (2 Solutions!!) Roel Van de Paar
2:57 What is happening to the flow of electricity in a magneto when you shut off power in a lawn mower Roel Van de Paar
3:30 Electronics: Please explain how this wireless electricity circuit works in simple way Roel Van de Paar
3:26 Electronics: Why speed is not directly proportional to torque in dc machine? (3 Solutions!!) Roel Van de Paar
3:27 Electronics: How to create a circuit to turn off LED when switch is "ON" and turn on when "OFF"? Roel Van de Paar
4:46 Electronics: Precise multi-point over-temperature control using comparator (4 Solutions!!) Roel Van de Paar
2:10 Electronics: Extremely noisy signal after voltage follower/buffer (2 Solutions!!) Roel Van de Paar
2:23 How to isolate coupled noise source in parasitic capacitance in high voltage pcb design? Roel Van de Paar
2:09 Electronics: ceil(log2(x)) or ceil(log2(x)) - 1 [repeat the post question] (2 Solutions!!) Roel Van de Paar
2:00 Electronics: Total current in a closed loop using Ampere's Circuital Law (2 Solutions!!) Roel Van de Paar
2:38 Electronics: How to turn on high-side MOSFET of a buck converter? (3 Solutions!!) Roel Van de Paar
1:51 Electronics: Are commonly available microcontrollers hardwired or microcoded? (2 Solutions!!) Roel Van de Paar
1:26 Electronics: Where to find documentation for definitions for AVR programming in C Roel Van de Paar
5:41 Is it important to file a new soldering iron tip before tinning? (9 Solutions!!) Roel Van de Paar
2:12 Electronics: Unusual behaviour between two seperate electrical circuits in a race-car Roel Van de Paar
2:19 Electronics: On a PCB, what does an Earth Ground prong (from a 3-prong plug) connect to? Roel Van de Paar
3:22 Electronics: Arduino-controlled slot cars - alternative to MOSFETs for speed control? Roel Van de Paar
3:59 Electronics: Convert 2s pulse into short pulse to wake up ESP8266 (3 Solutions!!) Roel Van de Paar
1:56 Electronics: Current sense resistor - Should I consider self-heating contribution? Roel Van de Paar
2:06 Electrical insulation resistance of TO-220 package with SIL pad and plastic shoulder washer? Roel Van de Paar
3:17 Electronics: Why do most of the non-volatile memories have logical 1 as the default state? Roel Van de Paar
