1:25 May a warm reset by pulling down the reset pin of the SoC cause the file system corrupts? Roel Van de Paar
2:31 Electronics: Stepper motor causes massive spikes in power supply when decelerating (2 Solutions!!) Roel Van de Paar
1:30 Can i use a slower clock rate for a CPU or a Microcontroller than the one it is supposed to use? Roel Van de Paar
3:02 Why do characteristic impedances matter only when traces are longer than half a wavelength? Roel Van de Paar
2:19 Electronics: Voltage regulator transistor circuit analysis (question about the emitter current) Roel Van de Paar
4:20 Electronics: Do AC coupled inputs suppress voltage offsets in an op amp? (5 Solutions!!) Roel Van de Paar
1:57 Is it possible to drive a HDMI output without exact clock frequencies (74.25 MHz, etc.)? Roel Van de Paar
2:01 Is the design decision for different frequencies in PAL and NTSC related to the AC mains power... Roel Van de Paar
2:10 Electronics: If I re-scale my input range for differential input to ADC, can I double resolution? Roel Van de Paar
3:24 Electronics: How to conduct "Transient Power" measurement according to ETSI EN 300 220-1 (v2.4.1)? Roel Van de Paar
2:37 Electronics: Simple accessible microcontroller for learning low level digital logic Roel Van de Paar
2:06 Is there a good practice approach to powering down peripheral devices (SPI, I2C, UART) which use... Roel Van de Paar
1:37 Electronics: How to convert light activated switch into dark activated switch? (2 Solutions!!) Roel Van de Paar
3:03 12V Signal -＞ Relay -＞ Voltage Regulator -＞ Arduino mega analogue input. Will this work? Roel Van de Paar
2:44 Electronics: Is unshielded untwisted pair cabling fine for audio? (3 Solutions!!) Roel Van de Paar
1:23 Why the simulation time of a synthesized netlist depends on the clock period at which it is... Roel Van de Paar
2:37 Electronics: Is 0603 vs 0402 assembly mass production cost optimization still relevant? Roel Van de Paar
2:42 Electronics: Can I groud 12v Negative and 5v Negativ at the same time? (2 Solutions!!) Roel Van de Paar
1:52 How would I go about generating a very small analog signal ( 0.06-0.08 V)? (2 Solutions!!) Roel Van de Paar
1:33 Electronics: Does tools for automation analysis image IC for extract netlist exist? Roel Van de Paar
2:04 Electronics: Gate and routing delays as a function of voltage and temperature (2 Solutions!!) Roel Van de Paar
1:24 Electronics: Is it possible to power down all the PLLs and VCO of a MAX 10 Device? Roel Van de Paar
2:26 Electronics: How should I connect / design this tactile push button on PCB & schematic? Roel Van de Paar
2:40 Electronics: Will a battery be damaged when in series with a low frequency AC signal source? Roel Van de Paar
4:53 How do batteries connected in parallel give more current than batteries connected in series? Roel Van de Paar
1:53 Electronics: Why did the Intel bubble memory chips have a hexadecimal label on them? Roel Van de Paar
1:29 What effect does using two different forms of solder mask on the same PWB have? Roel Van de Paar
2:24 Electronics: How can i design butterworth low and high pass filter? (2 Solutions!!) Roel Van de Paar
2:12 Electronics: Grounding Metal Object to Eliminate Static Electricity Using Electrical Ground Roel Van de Paar
3:49 Electronics: Can anything be done about this AVRISP mkII or is it dead? (2 Solutions!!) Roel Van de Paar
1:46 Electronics: How to tune an RF receiver with a microcontroller? (2 Solutions!!) Roel Van de Paar
2:25 Electronics: Limiting resistor for zener voltage regulator driven by transistor (2 Solutions!!) Roel Van de Paar
2:46 Electronics: Spectre - measuring subcircuit current with wild cards (3 Solutions!!) Roel Van de Paar
2:29 Electronics: Why does these capacitances have no effect on the output of this amplifier? Roel Van de Paar
1:36 Electronics: Reasons to use an analog temperature sensor instead of a digital one Roel Van de Paar
