3:49 Electronics: How do computers power so many lights on a keyboard? (4 Solutions!!) Roel Van de Paar
2:42 Electronics: Question about computer engineering circuits (noob question) (3 Solutions!!) Roel Van de Paar
2:00 Electronics: How can this MOSFET become overheated? How big should the heatsink be? Roel Van de Paar
2:36 Electronics: Why aren't resistors being used in this flip-flop used in static MOS RAM? Roel Van de Paar
4:09 Is there a practical method to verify whether the noise have CM component in this setup? Roel Van de Paar
2:47 Electronics: How does this tungsten rod not short circuit the batteries? (2 Solutions!!) Roel Van de Paar
3:16 Electronics: What precautions should I take when mixing analog audio and digital on the same board? Roel Van de Paar
3:13 Electronics: How do I (safely) arrange power for circuit from AC? (4 Solutions!!) Roel Van de Paar
2:18 Is there a formula describing the relationship between bit error rate, frame size, and... Roel Van de Paar
3:09 Electronics: Switch off this single cell lithium hi-power LED driver with protection circuit Roel Van de Paar
2:08 Electronics: Why are there 2 clock rates (core vs memory clock) in the GPU? (2 Solutions!!) Roel Van de Paar
2:11 Why a 750w electric drill costs about 30 , and a standalone 750w electric motor costs about 120 s Roel Van de Paar
2:19 What are the disadvantages to using an MCP2551 as a CAN transceiver for GMLAN / SW-CAN? Roel Van de Paar
4:35 Looking for feedback on my microcontroller-controlled boost converter (4 Solutions!!) Roel Van de Paar
2:01 What is the difference between high and low density anti-static foam in terms of protection... Roel Van de Paar
2:13 When two computer communicating(sending and receiving) with each other through the twisted... Roel Van de Paar
2:38 Electronics: Can VCC and ground be swapped on a microcontroller? (2 Solutions!!) Roel Van de Paar
3:45 Electronics: Using Thevenin's theorem, how do you find the Thevenin voltage? (3 Solutions!!) Roel Van de Paar
2:14 What is the maximum resistance that is allowed when connecting two grounds in a 5V unit? Roel Van de Paar
4:18 Electronics: Can I use thermal paste instead of solder for a SMD heat sink? (4 Solutions!!) Roel Van de Paar
3:05 Electronics: What do you call this type of component? (identifying a USB 3.0 connector) Roel Van de Paar
2:51 Electronics: NPN inverter alternative that takes up less space on the board (3 Solutions!!) Roel Van de Paar
3:05 Electronics: Precision with opamp in transimpedance amplifier configuration with LED as photodiode Roel Van de Paar
2:49 How to eliminate computer noises from audio on shared power supply (12v/5v buck converter)? Roel Van de Paar
2:34 How do CMOS switches behave when Vdd is grounded? What are the alternatives if they behave... Roel Van de Paar
6:20 Electronics: Practical ways to obtain Bode plots for an unknown circuit (8 Solutions!!) Roel Van de Paar
1:48 Electronics: 120vac to 180vdc @ 300ma, non-isolated current-limited (2 Solutions!!) Roel Van de Paar
2:35 Electronics: How to drive a high side mosfet with the L6388E driver? (2 Solutions!!) Roel Van de Paar
3:11 Electronics: How can I fix delay between Instruction and Program Counter? (2 Solutions!!) Roel Van de Paar
2:40 Why does signed (2's complement) binary multiplication have different procedure than unsigned? Roel Van de Paar
2:58 DC and low signal Analysis of Common Source Amplifier: wrong drain current and amplification? Roel Van de Paar
4:12 Electronics: Buck switching regulator based on ATtiny84a -- please critique! (2 Solutions!!) Roel Van de Paar
2:26 Unable to program ATSAML21 PCB via SWD - Problem with connection? (2 Solutions!!) Roel Van de Paar
5:46 How to find the system response given the transfer function without using Laplace transforms? Roel Van de Paar
1:47 Electronics: Measuring distance with ~300 m range and at least ~2 m accuracy as cheaply as possible Roel Van de Paar
2:15 Electronics: How to connect a PIC32MK 100-pin Motor Control Plug-In Module (PIM) for programming? Roel Van de Paar
