1:38 Electronics: Frequency bandwidth which transfers 95% of power of the signal (2 Solutions!!) Roel Van de Paar
2:45 Electronics: How to get the most power efficiency of solar panels? (2 Solutions!!) Roel Van de Paar
3:44 Electronics: 2.5 to 4.5 volts I need to level shift to 0 to 10 volts (3 Solutions!!) Roel Van de Paar
2:06 Electronics: Can we give instantaneous voltage higher than rated voltage of microcontroller? Roel Van de Paar
3:49 Electronics: Why is kerosene stopping my red LEDs from illuminating? (3 Solutions!!) Roel Van de Paar
2:44 Electronics: What type of power supply is this and how does it work? (2 Solutions!!) Roel Van de Paar
2:45 Electronics: How to calculate net force from a Lorentz Force Density in Magnets? (3 Solutions!!) Roel Van de Paar
1:45 Electronics: iMac 21.5" power supply is dead. 220 coming in, nothing coming out Roel Van de Paar
1:50 Electronics: Do I need any specific hardware and/or software to use Mechatrolink for communication? Roel Van de Paar
2:28 Electronics: Is program code copied to SRAM from flash on microcontroller? (4 Solutions!!) Roel Van de Paar
2:35 Trouble with Turning Off/Powering Off two systems at once, how should I approach this? Roel Van de Paar
2:07 Electronics: Powering three separate shaded pole axial fan motors with one 3-phase VFD Roel Van de Paar
2:53 Electronics: Why is my circuit in parallel with a voltage regulator overheating? (2 Solutions!!) Roel Van de Paar
3:32 The potential difference between primary and secondary wiring of an isolating transformer Roel Van de Paar
1:33 Electronics: Can someone explain how this truth table was filled in from a Mealy model? Roel Van de Paar
2:02 Electronics: Can roles of primary and secondary windings be reversed? (3 Solutions!!) Roel Van de Paar
2:53 Electronics: What should be the watts of solar panel and battery size (4 Solutions!!) Roel Van de Paar
1:27 Electronics: Why put 158K resistor between the input signals and negative input signal and ground? Roel Van de Paar
1:40 Final value theorem for transfer functions with more than one pole at origin (2 Solutions!!) Roel Van de Paar
1:19 Is the infrared sensor fabrication process(Using such materials HgCdTe, InSb, InGaAs) different... Roel Van de Paar
3:13 Electronics: Would this circuit work? NPN & PNP transistors ~in parallel: (2 Solutions!!) Roel Van de Paar
1:51 What is the main carrier in a semiconductor with n-type material being electrons and p-type... Roel Van de Paar
1:53 Electronics: For PIC16 how do I switch back to GPIO pin usage from SPI? (2 Solutions!!) Roel Van de Paar
4:35 How does the compensation resistor in an inverting amplifier compensate for the input bias current? Roel Van de Paar
2:39 Electronics: Why does microwave test equipment use N connectors? (3 Solutions!!) Roel Van de Paar
1:56 Electronics: Can an inductive load mess up an ohmmeter's reading (2 Solutions!!) Roel Van de Paar
3:51 Electronics: Is it possible to "stack" the outputs of 2 or more buck converters? (3 Solutions!!) Roel Van de Paar
4:47 How to read 0 -10V analog voltage with lower voltage tolerant ADCs without a voltage divider? Roel Van de Paar
2:21 Electronics: Why are different rms noise sources added in this way? (3 Solutions!!) Roel Van de Paar
2:30 Is this a correct way to do a low voltage cutoff for motorcycle use? (Zener diode + relay) Roel Van de Paar
2:06 Compare implementing a simple automation design on a MCU vs an FPGA/CPLD (2 Solutions!!) Roel Van de Paar
4:45 Can a DC brushless motor produce the same torque at different power levels? (4 Solutions!!) Roel Van de Paar
3:21 Electronics: Developing photoresist PCB with UV bank note checker (2 Solutions!!) Roel Van de Paar
2:58 Time delay dpdt relay using only pot, relay, and cap (discreet components and no transistors) Roel Van de Paar
