2:43 3.3V UART over 20cm ribbon cable inside an enclosure - EMC considerations (2 Solutions!!) Roel Van de Paar
2:13 Electronics: Can I use an inductive load in an ATX-to-bench supply project? (3 Solutions!!) Roel Van de Paar
1:33 Can ungrounded power line damage computer components & networking devices? (2 Solutions!!) Roel Van de Paar
1:35 Is it possible to change a USB's enumerated descriptors (from the OS side) after plugging it in? Roel Van de Paar
2:55 Electronics: Can I program a 3.3V ATmega MCU with 5V programmer (USBasp)? (4 Solutions!!) Roel Van de Paar
2:30 Electronics: How bad is it to places vias under a QFN thermal pad? (3 Solutions!!) Roel Van de Paar
2:44 Are low ESR SMD capacitors with jumper wires between their legs and the circuit OK? Roel Van de Paar
3:02 Why is channel capacity a factor of bandwidth instead of frequency? (2 Solutions!!) Roel Van de Paar
1:41 Electronics: Share same input with 2 different 32AVR Microcontroller (2 Solutions!!) Roel Van de Paar
1:53 What kind of hall effect sensor IC should I use to convert a frequency measurement in a... Roel Van de Paar
1:36 Electronics: Induced eddy currents and the power grid frequency (2 Solutions!!) Roel Van de Paar
3:24 Why does stator current increase with increasing load in a synchronous motor? (3 Solutions!!) Roel Van de Paar
1:57 How do I properly calculate the requirements for an on/off switch? (2 Solutions!!) Roel Van de Paar
2:06 Electronics: Ringing issue on I2C FM+ bus between MCU and few sensors - Power supply issue? Roel Van de Paar
2:54 What does a battery's C rating mean and how does it relate to its maximum discharge current? Roel Van de Paar
1:37 Doesn't the forward biasing voltage have to be greater than the barrier potential for any... Roel Van de Paar
2:25 Is there a more simple and less confusing way of solving laplace-tranformation equations? Roel Van de Paar
2:21 How to prevent an electrical motor surge from repeatedly blowing the fuse when it stalls? Roel Van de Paar
2:38 Electronics: Help choosing 3 phase motor and VFD for mini lathe project (2 Solutions!!) Roel Van de Paar
1:55 Electronics: RC AM senders/recievers: Changing the crystals, and using Servo PPM as a 1/0 switch Roel Van de Paar
2:47 What dimensions would L1 in this 433MHz tank circuit receiver be if it is actually 1.5 turns? Roel Van de Paar
4:04 Electronics: How to make a step down DC-DC converter fail safe? (4 Solutions!!) Roel Van de Paar
